Connect projects on remote servers, configure authentication, and recover SSH tasks.
Connect a server
Qoder reads files and runs commands in the remote directory. Make sure the SSH account can read and write the project, then connect the workspace:
- Open Settings → Remote connections and add a host. Choose a discovered SSH configuration entry or enter the host address, port, and username directly.
- Supply the authentication information offered by the form. For key authentication, select a valid private-key file readable on the local device. Configure a dedicated SSH client or configuration file as described in Specify an SSH client and configuration file, if needed.
- Connect and complete authentication. Once connected, select the remote project directory and create a workspace.
- Check the host, project path, and branch before sending a task.
Remote SSH compatibility and recovery
Qoder provides x64 and ARM64 EL7-compatible runtimes for environments meeting requirements including glibc 2.17, GLIBCXX 3.4.19, and CXXABI 1.3.7. Check distribution-specific dependencies and connection results; this is not a compatibility guarantee for every older Linux system.
If a failed managed SSH connection offers a Thin SSH retry, follow that prompt. Thin SSH uses a local Agent to access the remote host through SSH and differs from managed remote execution. This retry does not apply to WSL.
In an existing managed SSH task, start a Side Chat to work on a related question in the same remote environment.
If the SSH connection drops unexpectedly, the host can continue work it had already accepted. Wait for Qoder to reconnect automatically, or reconnect to the same host when prompted. Open the original task and check the synchronized reply and execution status before deciding whether to send it again.
Specify an SSH client and configuration file
If a host needs a particular SSH client or a separate configuration file, set its paths before connecting. Skip this setup when the defaults work for the host.
- Find the host in Settings → Remote connections. Disconnect it if connected, then choose Edit.
-
Fill in the fields you need:
Field Value If left blank SSH client path Absolute path to the SSH executable on this computer Select a client automatically SSH configuration file path Absolute path to the SSH configuration file on this computer Use the default configuration - Choose Save, then connect to the host. The changes apply only to future connections to this host.